Does Your Skincare Actually Get In? 17 Ingredients Rated
The 500 Dalton rule in plain words, then 17 common skincare ingredients rated by real molecular weight: which get in on their own, which struggle, and which stay on top, for better or worse.
Most skincare does not get in. The skin's outer layer keeps out most molecules heavier than about 500 daltons, and even small molecules mostly stop at the surface. Of the 17 ingredients rated here, 8 are small enough to get in on their own; the rest struggle or stay on top, and for a few of them, staying on top is the whole point. This page explains the 500 Dalton rule in plain words, rates each ingredient with its real molecular weight, and shows what else decides whether a formula reaches your skin.
What is the 500 Dalton rule?
The 500 Dalton rule says a molecule must weigh less than about 500 daltons to be absorbed through skin. A dalton is a unit of molecular weight. A water molecule weighs about 18 daltons.
The rule comes from a 2000 paper by Bos and Meinardi in Experimental Dermatology. They argued that larger molecules cannot pass the corneal layer, the outer layer of dead cells and fats. Their evidence was simple. Virtually all common contact allergens weigh under 500 daltons. So do the most used topical skin drugs, and every drug in a skin patch they reviewed.
Think of the outer layer as a brick wall. The cells are bricks, and fats fill the gaps like mortar. Small molecules can slip through the mortar. Big ones cannot. Our guide to the stratum corneum shows that wall in more detail.
It is a rule of thumb, not a law of physics. Some molecules a little over 500 still get through in small amounts. Many under 500 barely move. We cover why below, and our explainer on transdermal delivery goes further.
Does your skincare actually get in? The verdict table
Here are 17 common ingredients, sorted by weight. Molecular weights for single molecules come from PubChem, the chemistry database run by the US National Institutes of Health. Ranges for large materials come from published reviews, cited in each entry.
| Ingredient | Molecular weight | Verdict |
|---|---|---|
| Niacinamide | 122.1 Da | Gets in on its own |
| Salicylic acid | 138.1 Da | Gets in on its own |
| Tranexamic acid | 157.2 Da | Gets in on its own |
| L-ascorbic acid (vitamin C) | 176.1 Da | Gets in on its own, only at a low pH |
| Azelaic acid | 188.2 Da | Gets in on its own |
| Caffeine | 194.2 Da | Gets in on its own |
| Adenosine | 267.2 Da | Gets in on its own |
| Retinol | 286.5 Da | Gets in on its own |
| GHK-Cu (copper tripeptide-1) | 402.9 Da | Struggles |
| Ceramide NP | 584.0 Da | Stays on top (and that's its job) |
| Palmitoyl pentapeptide-4 | 802.1 Da | Struggles |
| Acetyl hexapeptide-8 (argireline) | 889.0 Da | Struggles |
| Collagen, hydrolyzed | 3,000 to 6,000 Da | Struggles |
| Collagen, native | 285,000 to 300,000 Da | Stays on top (and that's the problem) |
| Hyaluronic acid, low molecular weight | 20,000 to 300,000 Da | Struggles |
| Hyaluronic acid, high molecular weight | 1,000,000 Da and up | Stays on top (and that's its job) |
| PDRN | 50,000 to 1,500,000 Da | Stays on top (and that's the problem) |
| Exosomes | Particles about 100 nm across | Stays on top (and that's the problem) |
| Sunscreen filters | Chemical filters 228 to 362 Da; mineral particles often under 100 nm | Stays on top (and that's its job) |
"Gets in on its own" means the molecule is small enough to cross. It does not mean most of what you apply gets in. That part comes later.
Which skincare ingredients get in on their own?
Eight of the 17 weigh under 300 daltons, well below the line. Size is on their side.
Niacinamide, 122.1 Da. One of the smallest actives in skincare (PubChem). It loves water, and the outer layer is fatty, so it moves slowly. It still gets through on size alone.
Salicylic acid, 138.1 Da. Small, and it mixes well with oil (PubChem). That helps it move through the fatty outer layer more easily than water-loving actives.
Tranexamic acid, 157.2 Da. Small and water-loving, much like niacinamide (PubChem). Size is not its problem. Getting enough of it past the fats is.
L-ascorbic acid (vitamin C), 176.1 Da. Small, but fussy (PubChem). A 2001 study on pig skin found it must be formulated below pH 3.5 to enter skin. Absorption peaked at a 20% strength. Three common vitamin C derivatives did not raise skin levels of vitamin C in that study.
Azelaic acid, 188.2 Da. Small enough to pass (PubChem). How much gets in depends heavily on the cream or gel it sits in.
Caffeine, 194.2 Da. Small and water-loving (PubChem). Like niacinamide, it passes on size, but the fatty outer layer slows it down.
Adenosine, 267.2 Da. A small building block found in every cell (PubChem). It sits comfortably under the line.
Retinol, 286.5 Da. Small and oil-loving (PubChem). Of everything on this list, it has the easiest time with the fatty outer layer.
Which skincare ingredients struggle to get in?
These sit near or above the line, or have chemistry working against them. Some gets in. Most does not.
GHK-Cu (copper tripeptide-1), 402.9 Da. Under the line on size (PubChem). But it carries an electric charge and loves water, and both slow it down. In a lab test on human skin, copper from it did cross. That took 48 hours with the skin kept covered in solution the whole time. A thin layer that dries in minutes is a harder test.
Palmitoyl pentapeptide-4, 802.1 Da. Over the line (PubChem). The fatty tail helps it mix with the outer layer, but size works against it. In a 2014 study on human skin, microneedles gave a 2 to 22 fold stronger signal for three peptides, this one included.
Acetyl hexapeptide-8 (argireline), 889.0 Da. Well over the line (PubChem). In a study on human skin, a cream with 10% of it was left on for 24 hours. Most of it washed off the surface. Only 0.22% of the dose got in, and that stayed mostly in the outer layer. Our guide to acetyl hexapeptide-8 covers the rest.
Hydrolyzed collagen, 3,000 to 6,000 Da. Collagen broken into short pieces. A 2019 review puts those pieces at 3 to 6 kDa (a kDa is 1,000 daltons). That is 6 to 12 times the line. A 2020 review describes it as a good moisturizer at the outer layer.
Low molecular weight hyaluronic acid, 20,000 to 300,000 Da. Far over the line, yet it may not stay fully on top. In a 2016 study using Raman imaging, hyaluronic acid of 20 to 300 kDa passed through the outer layer. In a 60-day trial in 76 women, only the 50 and 130 kDa creams improved skin roughness around the eyes. Our guide to hyaluronic acid molecular weight explains the sizes.
Which ingredients stay on top, and is that bad?
Not always. Some ingredients are meant to work on the surface. Others are sold on what they would do if they got in.
Stays on top (and that's its job)
Ceramide NP, 584.0 Da. Just over the line, and very oily (PubChem). Ceramides are part of the mortar in the outer layer's brick wall. Applied on top, they help refill it. That is exactly where you want them. See ceramides and the skin barrier.
High molecular weight hyaluronic acid, 1,000,000 Da and up. The Raman study found hyaluronic acid of 1,000 to 1,400 kDa could not pass the outer layer. That is fine. It holds water at the surface and forms a smooth film. In the 60-day trial, every size tested, up to 2,000 kDa, improved hydration compared with a plain cream.
Sunscreen filters. Sunscreen should stay on top. It works by forming a layer that absorbs the sun's rays, and mineral filters also reflect them. Mineral filters, zinc oxide and titanium dioxide, are often used as particles under 100 nm. A 2019 review says they show a lack of absorption through skin. Many chemical filters are small: oxybenzone is 228.2 Da and octocrylene 361.5 Da (PubChem, PubChem). In an FDA-run trial, all six chemical filters tested were found in the blood after use. The authors stressed this does not mean people should stop using sunscreen. Our Korean sunscreen guide compares formulas.
Stays on top (and that's the problem)
Native collagen, 285,000 to 300,000 Da. Whole collagen weighs roughly 300 kDa, per the 2019 review. That is about 600 times the line. A collagen cream can form a film and hold water. It cannot add collagen to your skin, because the molecule cannot get in.
PDRN, 50,000 to 1,500,000 Da. PDRN is a family of DNA fragments, often from salmon. A 2021 review in Marine Drugs gives its range as 50 to 1,500 kDa. Our guide to PDRN and salmon DNA skincare has the details.
Exosomes, about 100 nm across. Exosomes are not molecules at all. They are tiny packages released by cells, with an average diameter of about 100 nanometers. Each one holds many proteins and fats, so daltons do not even apply. See our full look at exosomes in skincare.
Is molecule size the only thing that matters?
No. Size decides whether a molecule can get in at all. Several other things decide how much actually does.
- Oil and water balance. The outer layer is fatty. Molecules that mix with both oil and water cross best. Very water-loving actives, like niacinamide and tranexamic acid, move slowly.
- Charge. Charged molecules, like GHK-Cu, have a harder time with the fats.
- pH. Vitamin C is the clearest case. Above pH 3.5, it did not enter skin in the 2001 pig skin study.
- Concentration. More is not always better. Vitamin C absorption peaked at 20% in that same study.
- The formula. Solvents, oils and thickeners change how an active moves. The same molecule can behave differently in a gel and a cream.
- Your skin on the day. Dry, freshly cleansed or irritated skin behaves differently from calm, hydrated skin.
If small molecules get in, why does most skincare stay on the surface?
Because "can get in" is not the same as "gets in." The barrier is built to keep the outside world out, and it does that job well. Even small molecules lose most of the dose at the surface.
Over 95% of skincare stays on the surface and evaporates. Water and solvents dry off within minutes. What is left sits on top until you wash it off, or until it ends up on your pillowcase. The peptide study above shows the pattern. After 24 hours, most of the cream washed straight off the skin.
This is not your fault. You did not apply it wrong. Your skin is doing what skin is for. But it means the label strength tells you what is in the bottle, not what reaches your skin.
How do you give skincare a way in?
Microneedling is one well-studied option. Very fine needles make tiny, temporary openings, so a formula can get past the surface. In the 2014 human skin study, microneedles raised the peptide signal 2 to 22 fold.
The re:tones Tap Pen is built for this at home. It is the smallest nano microneedling device in the world, with 8 micron (µm) tips. Our R&D teams developed and made it in South Korea. The tips are made like computer chips, on semiconductor lines. It is not painful, and it leaves no redness. It takes about five minutes, once a week. The science page shows the tips up close.
The ampoule goes inside the cartridge, and the pen releases it as the tip meets skin. In an in vitro Franz cell test, 94.7% of the payload reached the dermal-epidermal junction in 4.7 minutes. Choose an ampoule by concern:
- re:vive-B3, niacinamide 21%, for visible pores and shine. re:vive-B3 is clinically proven: in a 47-person split-face clinical study in South Korea, oil dropped 78.2% and pore volume 34.7% in 14 days.
- re:clear-T, tranexamic acid 5%, for uneven tone and dark spots. Lab tested in South Korea.
- re:firm-8, acetyl hexapeptide-8 at 500 ppm with adenosine, for expression lines. Lab tested in South Korea.
Notice the mix. Niacinamide and tranexamic acid get in on their own, just not much of them. Acetyl hexapeptide-8 struggles. A way in matters for all three. Skincare should get in.
Frequently asked questions
What is the 500 Dalton rule?
It is a rule of thumb from a 2000 paper by Bos and Meinardi: molecules must weigh under about 500 daltons to be absorbed through skin. Larger molecules mostly cannot pass the outer layer. Some exceptions exist in both directions.
Does hyaluronic acid absorb into skin?
High molecular weight hyaluronic acid, around 1,000 kDa and up, stays on the surface and holds water there. Low molecular weight versions, 20 to 300 kDa, passed the outer layer in one imaging study. Both are far over 500 daltons.
Can collagen cream add collagen to your skin?
No. Native collagen weighs about 300,000 daltons, roughly 600 times the 500 Dalton line. Collagen creams can moisturize and form a film, but the collagen stays on top.
Does vitamin C serum absorb into skin?
L-ascorbic acid is small, at 176.1 daltons, but formula matters. A 2001 study found it must be below pH 3.5 to enter skin, with absorption peaking at 20%.
Do peptides absorb into skin?
Most cosmetic peptides weigh more than 500 daltons, so they struggle. In one study, only 0.22% of acetyl hexapeptide-8 from a cream got into human skin after 24 hours. Microneedles raised peptide delivery 2 to 22 fold in another lab study.
Is it bad that sunscreen stays on top of skin?
No, that is how sunscreen works. It forms a layer on the skin that absorbs UV rays, and mineral filters also reflect them. Some chemical filters are absorbed in small amounts, but FDA researchers said this does not mean you should stop using sunscreen.
